Cast Iron logo plate

Open to discussion about other railroads throughout the Great Southwest and beyond.
Post Reply
gjewers
Posts: 2
Joined: Wed May 25, 2011 6:04 pm

Cast Iron logo plate

Post by gjewers »

I have a large cast iron T&P logo plate. Don't have the measurements off hand as it is in storage. It is larger than the brass feedwater heater plates. Any ideas where this may have come from if it is,indeed, authentic? Thanks. gj

gjewers
Posts: 2
Joined: Wed May 25, 2011 6:04 pm

Re: Cast Iron logo plate

Post by gjewers »

I guess I wasn't too specific about this piece. But I have come to find out from a fellow collector at the Gaithersburg MD show that there were a few of these around over the past few years so that most likely it is not of any historical significance. (In short, a fake.) Oh well. It's still pretty neat and looks good, and fake or not, pretty scarce.

Post Reply